Surface recovered 0%
Drag across the stone
Laser cleaning, zero abrasion

The dirt goes. Everything else stays.

The laser removes the layer of dirt, salt, paint or rust without wearing down the material underneath. It's the method conservators use on protected monuments, because it doesn't sand, doesn't wet, and uses no chemicals. Now in the Balearics, for boats, villas and private heritage.

Marés stone

Teak

Marble

Boat hulls

Wrought iron

Dry stone

Bronze

Façades

Staircases

Walls & barriers

Stainless steel

Timber beams

Graffiti

Salt efflorescence

Rust

Old paint

The first step

Nobody commissions something they haven't seen. So we show it on your own stone.

01

Send us two photos

One general shot and one close-up of the surface. That's enough to identify the material and the type of soiling, and tell you whether laser is the right option. Sometimes it isn't, and we'll say so.

02

We clean a test patch, free

We come to your property or your mooring and treat a 20 × 20 cm square wherever you choose. No cost, no commitment. Takes a few minutes.

03

Decide with the result in front of you

You'll see the treated area next to the untreated one, in your material and your light. If it convinces you, we quote the rest on the spot. If not, you've lost nothing.

We cover Mallorca, Menorca, Ibiza and Formentera. If you'd rather not have a visit yet, we'll send you the catalogue with real samples treated in marés, teak, marble, iron and bronze.

Request a free trial Get the catalogue
Direct contact

Message us

A free 20 × 20 cm trial on your own material, no commitment. We reply within 24 hours by WhatsApp or phone call.

WhatsApp

What needs cleaning?
Message us on WhatsApp

By phone

If you'd rather talk it through. If we can't take the call right then, we'll call you back the same day.

Call · +34000000000

For marinas, architecture practices and property management firms, there's a separate channel. Information for partners

Why laser

Crust, old paint or rust absorb the pulse's energy; the clean material underneath reflects it. Once the excess layer is gone, ablation stops on its own — there's nothing left to keep absorbing.

An abrasive has no such limit: sandblasting keeps removing material for as long as the nozzle is held there, whether what's underneath is dirty or clean. The difference isn't one of intensity, it's one of mechanism — one switches itself off, the other depends on someone stopping it in time.

Laser cleaning leaves no abrasive to sweep off the garden, no sludge, no wash water, no product to store. On a boat, that means nothing removed goes into the harbour water.

Sandblasting
It rounds off edges and erases the quarry's saw marks. It also strips the stone's hardened outer skin, which is denser than the core — once it's gone, the surface is more porous and gets dirty again sooner. The change is irreversible.
Chemical stripping
The product stays trapped in the pore and can resurface as salts months later. In limestone it's worse: the cleaning acid dissolves the substrate itself, because limestone and acid are, chemically, the same kind of reaction.
Pressure washing
Water drives paint and dirt further into the material instead of removing it, and saturates the wall or beam with moisture. In wood, it also erodes the soft grain fibre and leaves grooves that don't come back.

Laser isn't the right choice every time. When it isn't, we'll say so before quoting — not after treating the surface.

If you manage someone else's site

Marinas, shipyards, heritage and property management

For marinas, shipyards, heritage architects, restorers and property management firms.

Working protocol on your site, fume and waste handling, work to a conservator's specification.

See information for partners